Rockshaft draft control7/22/2023 Then pull draft sensing lever (B) rearward until desired draft sensing sensitivity is obtained. The operating depth set-up will prevent the rockshaft from lowering all the way when the tractor begins to slip. Set position control lever stop (D) so control lever can be brought back to the same position. With tractor moving, push position control lever (A) forward to set implement operating depth. Initially place position control lever (A) in its fully rearward position and the draft control lever (B) in the fully forward (least draft) position. (See Positioning Center Link in this section for additional information.) Placing the lever toward the rear position reduces the amount of draft load required to override the position setting set by the position control lever (A) and raise the rockshaft.ĭraft sensitivity ranges can be changed by repositioning the center link. With lever placed fully forward to the position marked “off” (C), there is no draft sensing. The implement is raised slightly to get through tough spots so you do not have to shift to a lower gear.ĭraft control lever (B) controls amount of load required before hitch responds. The implement will raise and lower to follow the ground contours while maintaining a nearly constant depth. Operating with a fully mounted implement in hill and swale terrain. The rockshaft is equipped with variable draft control system. A-Rockshaft Position Control Lever B-Rockshaft Draft Control Lever C-Draft Sensing Off Position D-Position Control Lever Stop
0 Comments
Leave a Reply. |